In short
Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Wilton repairs the sensors and re-tests the opener's safety system.

Doors that won't close in Wilton
About three quarters of Wilton's residential land is zoned for two acres or more, with winding roads and wooded lots. In North Wilton and Cannondale, leaves and pine needles in the doorway are the daily cause from October through December, and mice in the wiring are the hidden one. In South Wilton and around Wilton Center, garages are closer together and busier, and a bracket bent by a car door or a bike is more likely. Near Gilbert Corners and Georgetown, older houses and barns have stone or uneven floors. Along the Norwalk River valley, morning fog leaves the lenses wet. Two steady lights mean the sensors are fine.
The usual reasons a door reverses or stays open
- Misaligned photo-eyes. A bin, a bike tire or a broom knocks one bracket a few degrees and the beam misses.
- Dirt, cobwebs or condensation on a lens. The sensor sees it as an obstacle.
- Low sun shining straight into the receiving eye. It happens at the same hour each day and clears up later.
- Damaged sensor wire. Staples, rodents and corrosion all break the thin low-voltage wire.
- Close limit or force out of adjustment. The door reaches the floor and the opener reads it as a collision.
What you can safely try yourself
Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.
Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.
How the repair is done
The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.
Around Wilton
- Gilbert Corners: Near the Route 7 and Route 33 junction, with a mix of older homes and newer builds.
- Cannondale: Around the Cannondale station along the Norwalk River, with older houses and detached garages.
See the full Wilton service area.